显示标签为“Programmeur de clé automobile”的博文。显示所有博文
显示标签为“Programmeur de clé automobile”的博文。显示所有博文

2013年2月16日星期六

Shock Airbag Reset absorbers common fault repair method

The check the shock absorbers state whether good:

Car traveling 10km parking on the pavement 
Airbag Reset of the poor road conditions, touch the shock absorber housing if it is not hot enough, the internal shock absorber without resistance, shock absorbers do not work. Proper lubricant can be added, and then the test case of fever, compared to the shock absorber internal lack of oil, add a little oil; otherwise defective shock absorber.

Firmly press the bumper, then release, then the shock absorbers work well if the car jumps 2-3.

The emergency brake when the car slowly driving the vehicle vibration is more intense shock absorber problem.

Remove the shock absorber of the upright, and the lower end of the connecting ring folder in the vise, pull compression damping rod several times, then there should be a stable resistance, pull up resistance should be greater than the downward pressure when resistance, such as resistance to unstable or no resistance, shock absorber internal lack of oil or damaged valve parts, repair or replacement of parts.

Determine the shock absorbers have a problem 
Opel Airbag Reseter  or failure should view the shock absorbers whether oil or traces of old oil spills.

If the shock absorber is no leakage phenomenon, you should check the shock absorbers connecting pins, connecting rods, connecting hole, rubber bushing for damage, Desoldering, break or fall off of. If these were normal, should be further decomposed shock absorbers, check with the gap between the piston and cylinder is too large, the cylinder with or without injury, the valve seal is good, valves and valve seat are tight fitting, as well as less the stretching of the shock absorber spring is too soft or broken, where appropriate, adopt a way to repair or for grinding parts.

In addition, the damper will appear in the actual use beep fault, this is mainly due to the spring frame or shaft of the shock absorber and the steel plate collides Mountings damage or loss, and the damper dust tube deformation, oil inadequate causes, reasons should be identified, to be repaired.

Shock absorber during inspection  
Programmeur de clé automobile repair should be dedicated test bench performance test, resistance frequency of 100 ± 1mm ​​done trip and the resistance of the compression stroke required.

2012年10月23日星期二

Cleaning Programmeur de clé automobile and conservation of leather seats

As early as in ancient times, humans   Programmeur de clé automobile  have learned to clothes made of animal fur to keep warm. Into modern society, with the rise of the leather manufacturing process, the advantages of leather products has also been further demonstrated, it become a symbol of the people to highlight the quality of life in many areas. The most widely used leather products and leather seats as the automotive sector, is also seen as an important indicator to measure a model of high-end or not, but the real value was not much to know how to conserve leather seats owners. In order to ensure consistent bright color and excellent texture leather seats, it is extremely necessary to its proper cleaning and conservation.
Installed seat cover with fabric seat chair surface cleaning, leather seats are often directly exposed to the interior environment, resulting in a greatly increased risk of chairs face contact with the stains, long time will inevitably become too dirty cause the leather pores clogging impact the permeability and feel of the leather. If the owner does not timely cleaning, in severe cases, there may lead to odor, damage to the physical health of the occupants. Therefore, in order to guarantee the life and ride comfort of the leather seats, leather seats of the regular cleaning is very critical.
The order of topics become more 
Puce de clé automobile  vivid, I went from a friend that borrowed a Buick Regal equipped with leather seats as props, to tell you how to properly clean and Conservation leather seats.
● First of all, it is recommended that you use a clean cloth to remove dust attached to the surface of the leather seats, in order to avoid the accumulation of dust. If conditions permit, leather seats, special one-time cleaning magic cloth can also be purchased to carry out the day-to-day care. This so-called magic cloth, the principles are similar with wet paper towels, but contains a substance not only has a cleansing effect, can also play a very good protection to the leather
Cleaning is finished, the chairs face dry with a dry cloth and use a hair dryer for quick drying, hair dryer can not use hot air, to avoid the chair surface overheating cortex damaged. Of course, the vehicle can also  
Renault CAN Clip V120 be placed in a cool and ventilated place, and open the door to dry naturally, so as to prevent the penetration of moisture the seat sponge, because wet leather surface is not only easy to re-absorb dust, a long time will be the cortex to produce affect
Leather seats conservation
In addition to the need for regular cleaning leather seats, daily care and maintenance is also important. If prolonged absence of any conservation measures are taken, it will make the fibrous tissue of the dermis internal change, resulting in the original protective film destroyed so that it appears dry, aging, stiff, cracking and bleaching phenomenon. In addition, even if some car owners adopted a number of conservation measures, if improper, the same may damage leather surface, affect their life. To this end, the the leather seats conservation process, you need to pay attention to the following points:
● smear protection agent
Protein and fat and other substances in the natural state in the dermis, old as time slowly lost, and ultimately lead to aging. Especially   
lexia-3 pp2000  requent rainfall in southern the dermis After repeated damp and dry, this aging phenomenon is more serious. Although the market a lot of leather cleaners have certain protective effects, after you complete each seat clean, better able to use the full maintenance the leather special protection agent on the seat, so the leather surface to form a layer of waterproof antifouling protection film. This will not only be able to reduce the moisture and dirt into the dermis internal, while fats nutrient supplement to the dermis, in order to effectively restore the softness of the leather and breathable, and extending its life