Shock Airbag Reset absorbers common fault repair method

The check the shock absorbers state whether good:

Car traveling 10km parking on the pavement  Airbag Reset of the poor road conditions, touch the shock absorber housing if it is not hot enough, the internal shock absorber without resistance, shock absorbers do not work. Proper lubricant can be added, and then the test case of fever, compared to the shock absorber internal lack of oil, add a little oil; otherwise defective shock absorber.

Firmly press the bumper, then release, then the shock absorbers work well if the car jumps 2-3.

The emergency brake when the car slowly driving the vehicle vibration is more intense shock absorber problem.

Remove the shock absorber of the upright, and the lower end of the connecting ring folder in the vise, pull compression damping rod several times, then there should be a stable resistance, pull up resistance should be greater than the downward pressure when resistance, such as resistance to unstable or no resistance, shock absorber internal lack of oil or damaged valve parts, repair or replacement of parts.

Determine the shock absorbers have a problem  Opel Airbag Reseter  or failure should view the shock absorbers whether oil or traces of old oil spills.

If the shock absorber is no leakage phenomenon, you should check the shock absorbers connecting pins, connecting rods, connecting hole, rubber bushing for damage, Desoldering, break or fall off of. If these were normal, should be further decomposed shock absorbers, check with the gap between the piston and cylinder is too large, the cylinder with or without injury, the valve seal is good, valves and valve seat are tight fitting, as well as less the stretching of the shock absorber spring is too soft or broken, where appropriate, adopt a way to repair or for grinding parts.

In addition, the damper will appear in the actual use beep fault, this is mainly due to the spring frame or shaft of the shock absorber and the steel plate collides Mountings damage or loss, and the damper dust tube deformation, oil inadequate causes, reasons should be identified, to be repaired.

Shock absorber during inspection   Programmeur de clé automobile repair should be dedicated test bench performance test, resistance frequency of 100 ± 1mm ​​done trip and the resistance of the compression stroke required.