How to do when launch x431 automotive engine overheating

Engine overheating is a common fault, and  launch x431  will lead to engine power sexual, economic decline, but also serious mechanical damage, such failure shall be immediately removed. Below Shaoxing car network editor to introduce you to exclude engine temperature failure "four-step".

See

Temperature is too high or the temperature indicator kept flashing to stop and check to see if the tank is normal cooling water, water tanks, water pipes and joints for leakage. Can be required to make up the cooling water and then continue driving through the appearance check were not unusual. If traveling some distance, and still found that the temperature is too high, stop checks and found that the cooling water to reduce a lot of this loss is mostly due to the water jacket of the cylinder block trachoma or perforation. Discovery of this failure, maintenance was not to be taken lightly.

Second touch

Engine temperature is too high, you can not touch   autoboss v30  on the temperature of the water pipes and underwater pipe to determine the fault lies. If the temperature difference between the two water pipes are great, can be judged as the thermostat is not working. Moment purchase less than accessories on the way, you can remove the thermostat emergency, immediate replacement to be back units.

Three put

If there is air in the cooling system, the formation of the gas barrier, so that the cooling water circulation undesirable, causing the engine temperature is too high. Deflated following practices can be used: engine speed operation, the tank lid gently twist open Shigo gas release, this time there will be a part of the cooling water flowing along with the gas, so repeatedly, until you feel the gas is discharged. Troubleshooting should replenish the cooling water.

Four red

Vehicle if driving on dirt roads or muddy road for a long time, there will be some dirt adhesion in the radiator, the passage of time, it will affect the cooling effect, causing the  mb star c3  water temperature is too high. Can use compressed air to blow the radiator grille, and then hosed.